Three voltage settings, two operating modes, and clear LED feedback put the essential controls where you can see them. The LOOKAH Seahorse 3.0 is an electric nectar collector built around a replaceable Seahorse coil and a 510 screw connection. Its 500mAh battery and Type-C charging support a self-contained, button-operated setup without a torch.
Choose manual control for a press-and-hold session, or use the timed automatic cycle with a compatible wax atomizer. Separate mode and power indicators show the selected voltage and remaining battery range, so you can check the device before you start.
What Sets the Seahorse 3.0 Apart
•Three selectable outputs: Switch between 3.2V, 3.6V, and 3.9V.
•Manual and automatic operation: Hold the button for direct control, or start a timed cycle when using a compatible wax atomizer.
•Replaceable heating component: The Seahorse coil connects through the device's 510 screw connection.
•Visible status feedback: Dedicated LEDs identify the active voltage and remaining battery range.
•500mAh built-in battery: Recharge through the Type-C port using a 5V USB input.
•Built-in protection system: The device monitors low battery, temperature, circuit status, output load, and activation time.
Three Voltage Settings With Color Feedback
Double-click the power button to switch between the three output levels. The mode indicator changes color with the selected voltage:
Green : 3.2V
Blue ： 3.6V
White: 3.9V
The color-coded indicator makes the active setting easy to confirm. Use only a voltage supported by the attached compatible coil or atomizer.
Manual Control or a Timed Automatic Cycle
In universal manual mode, press and hold the power button to activate a compatible wax or CBD atomizer. Release the button to stop output. A 25-second cutoff limits one continuous activation.
With a compatible wax atomizer, triple-click the button to enter automatic mode. The Seahorse 3.0 preheats for 15 seconds, then supplies automatic output for up to 25 seconds. You can press once during the cycle to change the voltage level, or triple-click again to exit automatic mode.
Manual mode gives you hold-to-activate control. Automatic mode provides a defined preheat and output sequence without requiring you to hold the button throughout the cycle.
Replaceable Seahorse Coil and 510 Connection
The Seahorse 3.0 uses a 510 screw connection for its replaceable Seahorse coil. The same connection can support compatible atomizers in the modes described above, but 510 threading by itself does not guarantee compatibility.
Before attaching a different coil or atomizer, confirm its type, resistance, and recommended voltage. Automatic mode is intended only for a compatible wax atomizer. If the device detects a short circuit, open circuit, unsupported resistance, or output overload, it disables output and uses the mode light to report the condition.
500mAh Battery With Type-C Charging
You can charge the built-in 500mAh battery through the Type-C port using a 5V USB power source with a charging current of 500mA. The power indicator lets you check the remaining charge range.
Green : 61-100% Remaining charge
Yellow : 31-60% Remaining charge
Red : 1-30% Remaining charge
During charging, the mode light rotates in red while the power light remains on. When charging is complete, the power light stays green and the mode light stays cyan. The device also powers off after 60 minutes of inactivity in standby mode.
How to Use the LOOKAH Seahorse 3.0
1.Attach the correct compatible Seahorse coil or atomizer to the 510 connection.
2.Press the power button five times within two seconds to turn the device on.
3.Double-click within 0.8 seconds to select 3.2V, 3.6V, or 3.9V. Check the mode light to confirm the setting.
4.For manual mode, press and hold the button, then release it to stop. For automatic wax-atomizer mode, triple-click within 1.2 seconds to begin the timed cycle.
5.Triple-click to leave automatic mode. Press five times within two seconds to turn the device off.
Allow the heated end to cool before touching, removing, or cleaning it. The full user manual remains the source for complete operating and safety instructions.
Is the LOOKAH Seahorse 3.0 an electric nectar collector or a dab pen?
Its primary positioning is as an electric nectar collector. Its 510-thread body can also drive compatible wax or CBD atomizers in universal manual mode, so you may find yourself comparing it with dab pens or wax pens when you research or shop for products. How the device can be used depends on the component you attach and the operating mode you select.
Can I use any 510-thread atomizer with the Seahorse 3.0?
No. A 510 connection does not guarantee universal compatibility. Confirm the atomizer type, resistance, and supported voltage before use. Automatic mode is intended only for a compatible wax atomizer.
What is the difference between manual and automatic mode?
Manual mode supplies output while you hold the button and stops when you release it, with a 25-second cutoff. Automatic mode is for a compatible wax atomizer and runs a 15-second preheat followed by up to 25 seconds of automatic output.
How do I change the voltage on the Seahorse 3.0?
With the device in standby, double-click the power button within 0.8 seconds. Green indicates 3.2V, blue indicates 3.6V, and white indicates 3.9V.
How do I know when the battery needs charging?
The power indicator turns red when the remaining charge is between 1% and 30%. Yellow indicates 31-60%, and green indicates 61-100%. If both the power and mode lights flash red eight times, recharge the device.
Kit Includes
1:Seahorse 3.0 *1
2:User Manual*1
3:Cleaning Brsush*1
4:Seahorse Coil*2
